Installation Guide – Please Read

Before Connecting the USB Siren to a PC…

Before you connect a USB Siren to your PC the setup program must be run. This is on the CD that came with the siren.

 

(When the CD is inserted, the following screen will automatically run.)

 



(After you have read and closed this guide, select ‘Click Here to Install Application’ to start the installation.)

 

 

 

When you run the setup program you will see the following.

 

 

After clicking ‘Next’, select where you want the main program to be installed. It is often best to let the PC choose (click ‘Next’ again.)

 


 

 

 

 

 

 Click ‘Install’ and the necessary files will be copied onto your PC:

 


 

You will see a green ‘progress bar’ showing how far the installation has to go:

 

IMPORTANT

Once all the files have been copied across, the setup program needs to install the ‘USB drivers’ for the Siren. The drivers are needed by the PC to be able to communicate with the Siren.

Whilst the drivers are being installed you will see the screen shown below:

 

 

This screen may be visible for a couple of minutes on some computers. For the installation to be successful, you must wait until the dialog box shown below pops up:

 

 

The software is now fully installed.

 

 

 

NB: The First Time You Connect Your Siren

The first time you connect a USB Siren to your computer, the PC will need a little time to locate the drivers it needs in order to communicate with the siren. You will see ‘New Hardware’ messages popping up at the bottom of your computer screen.

You should wait until the final message. This will read ‘Your new hardware is installed and ready to use’.